The goods the subject of the application (the goods) are:

Hot rolled structural steel sections in the following shapes and sizes, whether or not containing alloys:

The goods the subject of the application (the goods) are:

Aluminium extrusions that:

The goods the subject of the application (the goods) are:

Clear float glass (CFG) in nominal thickness of 3 to 12 millimetres (mm).

The tolerances for each of these thicknesses are set out in the following table.

The goods the subject of the application (the goods) are:

Clear float glass (CFG) in nominal thickness of 3 to 12 millimetres (mm).

The tolerances for each of these thicknesses are set out in the following table.

The goods the subject of the application (the goods) are:

The goods the subject of the application (the goods) are: 

Hot-rolled rods in coils of steel, whether or not containing alloys, that have maximum cross sections that are less than 14mm. The goods covered include all steel rods meeting the above description regardless of the particular grade or alloy content.

Goods excluded from the measures are:

Hot-rolled deformed steel reinforcing bar in coil form, commonly identified as rebar or debar, and stainless steel in coils.

Flat rolled products of alloyed steel plate commonly referred to as Quenched and Tempered (Q&T) steel plate (although some Q&T grades may not be tempered), not in coils, not further worked than hot rolled, of widths from 600mm up to and including 3,200mm, thickness between 4.5-110mm (inclusive), and length up to and including 14 metres, presented in any surface condition including but not limited to mill finished, shot blasted, primed (painted) or un-primed (unpainted), lacquered, also presented in any edge condition including but not limited to mill edge, sheared or profiled cut (i